Fixing Error Code 228 on Your Lennox® Furnace

Not sensing any heat and receiving error code 228 from your Lennox® furnace?

This means your heating system couldn’t adjust its pressure switch before starting. As a consequence, your system will not run for your protection.

Repairing or replacing this part is best left to the Experts at Bob Brown Service Experts in Tempe. Our NATE-certified technicians are among the elite in the industry. They’re well-qualified to handle all of your heating needs, including repairing a furnace error.

We want you to be absolutely satisfied with our quality furnace repair in Tempe. That’s why we back it with a 100% Satisfaction Guarantee* for a year.

How a Pressure Switch Works

This part plays an important role as your furnace prepares to warm your space.

Here’s what goes on after your thermostat’s call for heat:

  • Your furnace’s control board begins running the draft inducer blower motor. This drains combustion gases from the heat exchanger and brings in new gas and air so the burners can fire.
  • When the pressure switch senses that enough air is being pulled into the burners, it closes and commands the control board to ignite the furnace.
  • Your furnace ignites and creates heat.

What Happens When a Pressure Switch Breaks Down

When your pressure switch isn’t operating the way it should, you’ll likely hear the fan run and the switch clicking a few times before the furnace turns off completely. When a part isn’t performing right, your furnace will turn off to protect you.

Your furnace will show you something is wrong with a red flash from its indicator light, which it uses to display error codes. It uses this red light to flash code, like Morse code.

You may notice short flashes or an alternating slow flash as it transmits a fault code.

Estimated Repair Cost for Furnace Error Code 228

Before replacing the switch, your Bob Brown Service Experts Expert will look at other parts of your furnace first. Some other issues can also cause the error code, like a clogged vent or cracked hose.

The bill to repair your furnace depends on the issue with it and how long it takes to fix it.

If your pressure switch needs to be replaced, you can anticipate to pay between $40 to $350.

Count on the Experts at Bob Brown Service Experts

If you need furnace repair, turn to the technicians from Bob Brown Service Experts to check out the fault code and fix the problem to your standards.

Call us at 623-243-4517 or schedule an appointment online today.